{"id":424,"date":"2008-01-25T20:04:39","date_gmt":"2008-01-26T00:04:39","guid":{"rendered":"\/blog\/?p=424"},"modified":"2008-01-25T23:11:54","modified_gmt":"2008-01-26T03:11:54","slug":"laptop-woes","status":"publish","type":"post","link":"https:\/\/www.holypotato.net\/?p=424","title":{"rendered":"Laptop Woes"},"content":{"rendered":"<p>Way back in 2004 or so, my dad bought a new laptop for himself, but found out after getting it home that it was widescreen, and he didn&#8217;t like that, so he stuck to his old 4:3 for a while longer. I started using the new laptop, which he was keeping as a spare in case anything happened to his old one (he can&#8217;t afford to go a day without a computer). It was a pretty powerful model, a heavy desktop replacement with a P4 3 GHz processor, and a dedicated graphics card (a mobile radeon 9000, pretty crappy by the desktop standards of the time, but a revolution for laptops). That was good enough to play World of Warcraft on, which I did, and slowly the laptop went from something I borrowed from my dad while I was in town visiting to <i>my<\/i> laptop, which I brought to conferences, presentations, etc.<\/p>\n<p>It&#8217;s always been a heavy, hot beast, and any little bit of blockage of the fans (even just a tablecloth on the table) will cause it to overheat and crash &#8212; if I&#8217;m going to use it for a long period of time, I prop the back up with something to improve airflow. That&#8217;s been kind of annoying, but it was something that could be manged. Then it started developing problems with the power supply not working properly. A loose connection of some sort that could be fixed by putting something under the power cord to keep it up at an angle and force a connection. Lately though, that&#8217;s been getting harder to accomplish, and it&#8217;s also been overheating and crashing more often. While at my parents&#8217; house for the holidays it crashed over a dozen times (and I&#8217;m not even gaming on it much!).<\/p>\n<p>I&#8217;ve tried to repair the bad power connection before, but after taking apart the case, I found some sort of plastic connection right there that I couldn&#8217;t remove, snap our, or unscrew, so I couldn&#8217;t even see the board the power connector attaches to, let alone find a way to solder it. For a while I&#8217;ve been thinking about just getting a new laptop: while this one is still reasonably powerful, responsive, and all the other things I need in a laptop, it&#8217;s just too damned annoying and unpredictable to use. Of course, a new laptop is really expensive (especially if I insist on getting a dedicated graphics card &#8220;just in case&#8221; I need to game on it), even with the boxing day sales (I&#8217;m still looking at about $1000!). That&#8217;s a waste of a lot of money, particularly since I only need one for visiting my parents and going to conferences. At my parents, I could set up a desktop somewhere to just check my email, or borrow one of my siblings&#8217; computers. And I could borrow a laptop from Wayfare or even take one of the slow work ones when I have to go to a conference&#8230; <\/p>\n<p>Fortunately, <a href=''http:\/\/www.laptoprepair101.com\/laptop\/2006\/01\/28\/toshiba-satellite-m35x-a75-power-jack-problem\/comment-page-1\/#comments\">I&#8217;ve found instructions<\/a> for repairing this apparently systematic problem with the Toshiba A70&#8217;s. I finally got around to doing the repair today, <a href=\"http:\/\/www.irisvista.com\/tech\/laptops\/ToshibaA75\/satA75_1.htm\">thanks especially to diassembly instructions<\/a> I found. It took me about 3 hours to do total, with disassembly about 2 hours of that (largely because I was nervous and had never stripped a laptop down that far before). I have to say that having a half dozen Tim Horton&#8217;s cups in my office to collect screws was quite handy, since there are at least 4 different kinds of screws in there. The disassembly didn&#8217;t go perfectly smoothly: a large number of parts are held together by snap-together plastic, and it&#8217;s really held together well. At one point I snapped off a tiny plastic tab trying to free the upper case cover, but I don&#8217;t think I could have been any more gentle with it since a lot of pressure seemed to be needed to free pretty much every part, and I scratched up the case a fair bit using a tiny screw driver to pry those parts off. After that, I got really nervous about the part where I have to take the motherboard out of the case to get at the &#8220;top&#8221; side of the power supply connector. Looking from the exposed\/&#8221;bottom&#8221; part where the solder is, the power supply terminal had been visibly burned out and looked like a poor connection. It tested fine with a multimeter, though I think resistivity was not a problem, but rather intermittent complete contact breaks. Not having much experience with solder I got someone from work to do it, which took him all of 30 seconds. I haven&#8217;t had much of a chance to test it, but the power lights did light up immediately after I plugged it in upon reassembly. No jiggling or holding it at weird angles required! Since I didn&#8217;t take it out to really clean off the power connector like the instructions above recommend, there&#8217;s a good chance this problem will recur. However, I figure I bought myself another year or so, and now that I have experience at it, this process shouldn&#8217;t be too bad to repeat in that amount of time. One more round (for a total of 2 extra years) and this beast will be thoroughly obsolete and ready for replacement. <\/p>\n<p>Unfortunately, I didn&#8217;t have my camera anywhere handy to document the process. I did learn a bit more about the weight distribution of the computer. I figured it was something like 1\/3 battery, 1\/3 system case, 1\/3 screen, but it&#8217;s 8.5 pounds are actually mostly concentrated in the battery and screen. Despite the intense amount of heatsinks and how seemingly strong the case is, the keyboard\/motherboard part of the computer is actually fairly light. While I&#8217;m not impressed with the crappy power supply connection problem with this laptop, I have to say that I&#8217;m glad Toshiba stamped most of the plastic bits beside screw holes indicating what size screw goes where. Very helpful for putting the right screw in the right place when reassembling.<\/p>\n","protected":false},"excerpt":{"rendered":"<p>Way back in 2004 or so, my dad bought a new laptop for himself, but found out after getting it home that it was widescreen, and he didn&#8217;t like that, so he stuck to his old 4:3 for a while longer. I started using the new laptop, which he was keeping as a spare in [&hellip;]<\/p>\n","protected":false},"author":2,"featured_media":0,"comment_status":"open","ping_status":"open","sticky":false,"template":"","format":"standard","meta":{"footnotes":""},"categories":[14],"tags":[],"_links":{"self":[{"href":"https:\/\/www.holypotato.net\/index.php?rest_route=\/wp\/v2\/posts\/424"}],"collection":[{"href":"https:\/\/www.holypotato.net\/index.php?rest_route=\/wp\/v2\/posts"}],"about":[{"href":"https:\/\/www.holypotato.net\/index.php?rest_route=\/wp\/v2\/types\/post"}],"author":[{"embeddable":true,"href":"https:\/\/www.holypotato.net\/index.php?rest_route=\/wp\/v2\/users\/2"}],"replies":[{"embeddable":true,"href":"https:\/\/www.holypotato.net\/index.php?rest_route=%2Fwp%2Fv2%2Fcomments&post=424"}],"version-history":[{"count":0,"href":"https:\/\/www.holypotato.net\/index.php?rest_route=\/wp\/v2\/posts\/424\/revisions"}],"wp:attachment":[{"href":"https:\/\/www.holypotato.net\/index.php?rest_route=%2Fwp%2Fv2%2Fmedia&parent=424"}],"wp:term":[{"taxonomy":"category","embeddable":true,"href":"https:\/\/www.holypotato.net\/index.php?rest_route=%2Fwp%2Fv2%2Fcategories&post=424"},{"taxonomy":"post_tag","embeddable":true,"href":"https:\/\/www.holypotato.net\/index.php?rest_route=%2Fwp%2Fv2%2Ftags&post=424"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}